Maximize 
GW Instek GLP-1A
Logic pulser can be used to perform in-circuit testing of TTL, CMOS, and many other logic devices at a maximum of 50MHz
Search
Categories
New
Used
- Accessories (203)
- Amplifiers (30)
- Analyzers and Accessories (139)
- Antenna (2)
- Attenuators (26)
- Audio Instruments (37)
- Cable Testers (6)
- Calibrators / Standards (23)
- Clamp meters (5)
- Climate Chambers (2)
- Communications Analyzer(GSM) (18)
- Counters (67)
- Digital IC Tester (1)
- Directional Couplers (5)
- Electrical Testers (3)
- EMC Tests (9)
- FFT-Analyzers (5)
- Generators (266)
- Higrometry (1)
- Hipot and Ground Resist. Testers (19)
- Logic Analyzers (4)
- Multimeters (43)
- Network Analyzers (103)
- Oscilloscopes (184)
- Power Meters (84)
- Power Supplies / El. Loads (413)
- Powertool and Meters (7)
- Radio Communication Testers (30)
- RF - / Microwave Components (2)
- RLC meters / Component Testers (103)
- Sound Level Meter (1)
- Test Receiver (1)
- Tools (18)
- Voltage display (1)
Manufacturers
Maximize Features
※ Combining a Logic Probe and Pulser Combined into One
※ Probe for Troubleshooting Digital Circuits
※ Operating Voltage: 4VDC ~ 18VDC
※ Maximum Input Signal Frequency: 50MHz
※ TTL: Logic “1”>3.0V±0.25V, Logic”0”<0.75±0.25V
※ CMOS: Logic “1”>60%VCC±5%, Logic”0”<15%VCC±5%
※ Minimum Detectable Pulse Width: 10nsec
※ Pulser: Sync input impedance 120kΩ
※ Pulse Repetition Rate: Switchable 0.5/400Hz
※ Pulse width: 10μsec
※ Dimensions & Weight: 18(W)x210(H)x18(D)mm, Approx. 50g
| LOGIC PROBE | |
| Maximum Input Frequency | 50MHz |
| Input Impedance | 120kΩ |
| Operating Voltage | 4V DC (minimum) 18V DC (maximum) |
| TTL | Logic "1" (HI LED) >3.0V +0.25V |
| Logic "0" (LO LED) <0.75V +0.25V | |
| CMOS | Logic "1" (HI LED) >60%Vcc +5% |
| Logic "0" (LO LED) <15%Vcc +5%, <40% +5% (For 7 ~ 18Vcc) | |
| LOGIC PULSER | |
| Sync Input Impedance | 1MΩ |
| Pulse Rate | 0.5/400pps |
| Pulse Width | 10μS |
| Output Current | 100mA sink/source |
| Square Wave Output | 5mA sink/source |
| Operation Voltage | 5 ~ 15V DC |
| Output Protection | 20V DC (maximum 30 sec) |
| Input Protection | 120V DC (maximum 30 sec) |
| Measurement Point Protection | 35V DC (maximum 30 sec) |
| DIMENSIONS & WEIGHT | |
| 18(W) x 210(H) x 18(L) mm Approx. 50 g | |
-
- -20% 880,68 € 704,54 €
Contact us